somagaze
09-02-2003, 07:17 PM
This will be my last resort before i call ASUS. I am trying to connect the onboard firewire to my case and am having several questions. First of all to state my hardware again:
ASUS P4C800 Deluxe
Thermaltake Xaser III Super Tower
The concern is the wires required for the connection, sadly thermaltake does not have an adapter that has all the connections in the correct order. In the case manual, the wires are listed as:
GND
GND
VG
VP
TPA+
TPA-
TPB+
TPB-
this is the online user's manual for the board: http://www.asus.com/pub/ASUS/mb/sock478/P4C800/e1224_p4c800.pdf Check page 56 for the layout of the firewire connection.
Now, the TPA's and the TPB's are easy to install. the case manual goes on telling how to install the other wires:
Power Pin: connect VP to that
Ground Pin: connect VG to that (nex to VP)
Ground Pin: connect the two other GND connectors to those
So, there is only one power pin with the case and there are two +12v connections on the board. Which one do i connect the VP cable to?
ASUS P4C800 Deluxe
Thermaltake Xaser III Super Tower
The concern is the wires required for the connection, sadly thermaltake does not have an adapter that has all the connections in the correct order. In the case manual, the wires are listed as:
GND
GND
VG
VP
TPA+
TPA-
TPB+
TPB-
this is the online user's manual for the board: http://www.asus.com/pub/ASUS/mb/sock478/P4C800/e1224_p4c800.pdf Check page 56 for the layout of the firewire connection.
Now, the TPA's and the TPB's are easy to install. the case manual goes on telling how to install the other wires:
Power Pin: connect VP to that
Ground Pin: connect VG to that (nex to VP)
Ground Pin: connect the two other GND connectors to those
So, there is only one power pin with the case and there are two +12v connections on the board. Which one do i connect the VP cable to?