RampageIII
04-13-2003, 06:39 PM
you can chech the angle range of a wu through setispy and other such add-ons. you can also look in the work_unit.sah file and searchyou can chech the angle range of a wu through setispy and other such add-ons. you can also look in the work_unit.sah file and search for "angle_range="
An average angle range would be .417
VHAR's are above 1.00
VLAR are those below .300
the above figures are not exact. you will see some slow down between normal and VLAR's and some speed increase between normal wu's and VHAR's. A good look at the setispy log will give you a good range over time. for "angle_range="
AnandTech Forum
An average angle range would be .417
VHAR's are above 1.00
VLAR are those below .300
the above figures are not exact. you will see some slow down between normal and VLAR's and some speed increase between normal wu's and VHAR's. A good look at the setispy log will give you a good range over time. for "angle_range="
AnandTech Forum