causticVapor
01-18-2003, 07:06 PM
Here's a list of what I'm selling. I take cold, hard cash. Location, Germany. PM me or email me at alex_world at hotmail.com if you are interested. Prices are as is plus shipping.
$65 Pentium III 733EB Coppermine
$15 Tekram slotket slot-1 to PPGA/370 converter
$15 each Asus TUA266 BIOS chips
$2 Koolance Pentium 4 socket 478 CPU-200 retention clips
Pentium III 733EB Coppermine -- Perfectly Functioning Chip. Used for a year.
- Innovatively Compact Socket 370 Form Factor.
- 256KB Advanced Transfer Cache With a 256-bit-wide Datapath.
- Streaming SIMD Extensions for an Enhanced, Fluid Multimedia Experience.
- Advanced 133MHz Front Side Bus for Extremely Rapid Access to System Memory.
- Made in the Philippines.
- SL4CG S-Code.
- 7048A105-0570 Batch Serial.
- A Latter Stepping Made in 2000 With a 1.7v core for Cool, Low-Power-Consumption Operation.
- Overclocks to 914MHz without any voltage alteration. (I'm certain it can make it to 1GHz in combination with a good motherboard)
- Has Always Been Kept at 35 Degrees Celsius for Maximum Transistor Longevity.
- Has Never Been Subjected to the Cruel Act of Overvolting.
Tekram slotket -- Supports PPGA celeron CPUs in the range of 333-533 MHz. Allows one to run a Mendochino celeron in a slot 1 motherboard. Supports FSB frequencies of 66/100MHz that can be changed with a jumper, and has pass-through jumpers for core voltage, although it has no voltage regulator. Is completely dependent on the motherboard for processor electrical and BIOS support. However, skilled people can alter it to accept coppermines and even tualatins, if the motherboard supports such processors. Frequency and voltage values should correspond to the BIOS. It was used with a mendochino celeron 400 and I've experienced no problems at all over a span of three years.
Asus TUA266 BIOS chips -- both are functional. One is an ST Micro with the following markings:
Line 1 - 39SF020A
Line 2 - 70-4C-PH
Line 3 - 0102208-A
The other is winbond:
Line 1 - W49F002U-12B
Line 2 - 204GH214458501SA
Both are flashed with the latest BIOS revision.
Koolance Pentium 4 socket 478 CPU-200 retention clips -- brand new and will adapt any CPU-200 waterblock to a Pentium 4 or Celeron in the socket 478 form factor. If you have ones that are bent or broken, then this is the deal for you.
Well, folks, that's all for now... hope at least one of you is interested....
$65 Pentium III 733EB Coppermine
$15 Tekram slotket slot-1 to PPGA/370 converter
$15 each Asus TUA266 BIOS chips
$2 Koolance Pentium 4 socket 478 CPU-200 retention clips
Pentium III 733EB Coppermine -- Perfectly Functioning Chip. Used for a year.
- Innovatively Compact Socket 370 Form Factor.
- 256KB Advanced Transfer Cache With a 256-bit-wide Datapath.
- Streaming SIMD Extensions for an Enhanced, Fluid Multimedia Experience.
- Advanced 133MHz Front Side Bus for Extremely Rapid Access to System Memory.
- Made in the Philippines.
- SL4CG S-Code.
- 7048A105-0570 Batch Serial.
- A Latter Stepping Made in 2000 With a 1.7v core for Cool, Low-Power-Consumption Operation.
- Overclocks to 914MHz without any voltage alteration. (I'm certain it can make it to 1GHz in combination with a good motherboard)
- Has Always Been Kept at 35 Degrees Celsius for Maximum Transistor Longevity.
- Has Never Been Subjected to the Cruel Act of Overvolting.
Tekram slotket -- Supports PPGA celeron CPUs in the range of 333-533 MHz. Allows one to run a Mendochino celeron in a slot 1 motherboard. Supports FSB frequencies of 66/100MHz that can be changed with a jumper, and has pass-through jumpers for core voltage, although it has no voltage regulator. Is completely dependent on the motherboard for processor electrical and BIOS support. However, skilled people can alter it to accept coppermines and even tualatins, if the motherboard supports such processors. Frequency and voltage values should correspond to the BIOS. It was used with a mendochino celeron 400 and I've experienced no problems at all over a span of three years.
Asus TUA266 BIOS chips -- both are functional. One is an ST Micro with the following markings:
Line 1 - 39SF020A
Line 2 - 70-4C-PH
Line 3 - 0102208-A
The other is winbond:
Line 1 - W49F002U-12B
Line 2 - 204GH214458501SA
Both are flashed with the latest BIOS revision.
Koolance Pentium 4 socket 478 CPU-200 retention clips -- brand new and will adapt any CPU-200 waterblock to a Pentium 4 or Celeron in the socket 478 form factor. If you have ones that are bent or broken, then this is the deal for you.
Well, folks, that's all for now... hope at least one of you is interested....