NOHTO
11-01-2002, 11:05 PM
I Have a Abit AT7 (the first one not the new max2) I am trying to load win xp on the highpoint controler in a raid 0. I have 2 maxtor 20 gig drives. I have set up raid on this board several times with no problems. Win 2k loaded no problem and then tried to load winxp on 2nd partition (dual boot, because I couldn't get xp to load so I tried win 2k first) and when I get to the screen that says push any key to boot from cd it flashes setup is inspecting your hardware and then it goes blank. It doesn't lock up because I can hit Ctrl Alt Dlt and it resets. If I put Win2k cd in and repeat the above steps it starts fine. If I hook up a seperate HD on the regular IDE channels it starts Ok with xp cd.
Different things I have tried:
Vid card
Ide cables
Hard drives
Turning off ACPI in bios
CD rom
Different Version of XP
Master/Cable Select settings on HD
Other Hardware I am using:
XP2200
Corsair XMS 3500 512
Enermax 435W PS (Checked Voltage 5.12 and 12.45)
Different things I have tried:
Vid card
Ide cables
Hard drives
Turning off ACPI in bios
CD rom
Different Version of XP
Master/Cable Select settings on HD
Other Hardware I am using:
XP2200
Corsair XMS 3500 512
Enermax 435W PS (Checked Voltage 5.12 and 12.45)