Pics of the Insides of your computer!

[voogru]

i know how to flip it around im not that dumb http://sysopt.earthweb.com/forum/wink.gif
its flipped around k?

[This message has been edited by voogru (edited 02-07-2001).]

[Barney]

Sorry, you must have given me the wrong impression. http://sysopt.earthweb.com/forum/wink.gif

Ronald

[spuck]

voogru;did u make the heatsink?wish i had a cam.

[seti]

Barney is right. When the fan is sucking you should have the shroud on. That way more air is forced to enter the heatsink lower on the pins. That way there's less of a short-cut for the air to take from the sides of the heatsink into the fan. More air passing on more surface area equates to better cooling...at least in theory. You may have found it works better the way you have it.

The shroud is generally better left off when blowing air onto the heatsink because there's less back pressure to decrease the fans efficiency.

I haven't exactly read this anywhere, it's just what make sense to me. So if I'm completely backwards on this someone please correct me. http://sysopt.earthweb.com/forum/smile.gif

[This message has been edited by seti (edited 02-07-2001).]

[NDC]

<IMG SRC="http://www.geocities.com/ndcmj/3pics.jpg" border=0>

[struggles]

Dont have any pictures to post, although I doubt I would after seeing your guys killer systems. NDC you are a serious computer nut. I am impressed.Hmmmmm......if I sell my car I could order that asus board with a gig t-bird and a ........................................ http://sysopt.earthweb.com/forum/smile.gif

[voogru]

I got a few nice pics!

<IMG SRC="http://www.geocities.com/voogru/pic1.jpg" border=0>
This one shows the crappy heastink on my overclocked ATI rage fury at 120/120 from 90/90 runs pretty good!

<IMG SRC="http://www.geocities.com/voogru/pic2.jpg" border=0>

This pic shows you how I cheaply attached the heastink to the video card. i put a tad of artic silver and tried some school glue the card always locked up once i did the little modification it runs like a dream http://sysopt.earthweb.com/forum/smile.gif

<IMG SRC="http://www.geocities.com/voogru/pic3.jpg" border=0>
This one is a pic of the insides most of the insides at least!
<IMG SRC="http://www.geocities.com/voogru/pic4.jpg" border=0>
This one show the Nice cable rounding i have done. Im too chickin too do that ATA/66/100 80Pin wire tho http://sysopt.earthweb.com/forum/frown.gif
this is a decent pic of the heatsink which is SUCKING air from the cpu so there is no shroud http://sysopt.earthweb.com/forum/smile.gif

<IMG SRC="http://www.geocities.com/voogru/pic5.jpg" border=0>
an Upwards view of the hdd and cables http://sysopt.earthweb.com/forum/smile.gif

<IMG SRC="http://www.geocities.com/voogru/pic6.jpg" border=0>
a view of the whole thing http://sysopt.earthweb.com/forum/biggrin.gif

<IMG SRC="http://www.geocities.com/voogru/pic7.jpg" border=0>
This shows you how i transfer files from my dads comp! when i do a large download like about 100MB im not about to split that file into 100 Pieces and make 200 round trips!

so whats yours look like?

Post ure pics here!

EDIT: SPELLING!
EDIT: added Pic!
EDIT: added another pic!



[This message has been edited by voogru (edited 02-07-2001).]

[Barney]

What temperature does your processor run at? You say you're (the fan http://sysopt.earthweb.com/forum/wink.gif ) sucking the from the heatsink so you don't use the shroud. I can see on the pic it's sucking, but you shouldn't use the shroud when the fan is blowing ! That means you have to put on the shroud or turn the fan upside down.

Ronald

[jaida]

There ya go, I got too many wires to deal with
http://members.home.net/ovclock/inside1280.jpg




[This message has been edited by jaida (edited 02-09-2001).]

[thekingofpain]

Maybe youve seen mine before, I especially like this shot of my modified MX (replaced today by a Radeon DDR64vivo)
<IMG SRC="http://b.PostMyPic.com/b.nsf/Z/vcIEQL/$file/vc.jpg" border=0>

HAH! aint gotta crack my case open to take pics...
<IMG SRC="http://b.PostMyPic.com/b.nsf/Z/thirdview4QHVF/$file/thirdview4.jpg" border=0>

<IMG SRC="http://b.postmypic.com/b.nsf/Z/MOD4TTKY/$file/MOD4.jpg" border=0>

[ThiemeMD]

My water cooled T-Bird (overclocked of course http://sysopt.earthweb.com/forum/smile.gif to 1250mhz, on an ABIT KT7-Raid.

The resivor and pump:

<IMG SRC="http://www.geocities.com/thiememd/pics/resivor_pump.jpg" border=0>

The water block:

<IMG SRC="http://www.geocities.com/thiememd/pics/water-block.jpg" border=0>

Two 120mm fans blowing up through the radiator:

<IMG SRC="http://www.geocities.com/thiememd/pics/fans.jpg" border=0>

The raditor, (a transmission cooler):

<IMG SRC="http://www.geocities.com/thiememd/pics/radiator.jpg" border=0>

[spuck]

nice job t.k.o.p. are there 4 fans?im going
to paint my puter camo so no one sees it.ThiemeMD,does it get that hot u need a trans cooler?i know a lot about cars but not puters.i like it anyway!!!!!!!!!!

[This message has been edited by spuck (edited 02-08-2001).]

[thekingofpain]

WOW!!! crank that image size back alittle bit... <IMG SRC="http://b.postmypic.com/b.nsf/Z/MOD4TTKY/$file/MOD4.jpg" border=0>

This helps: http://www.irfanview.com
<IMG SRC="http://b.PostMyPic.com/b.nsf/Z/inside1280v2DJFP/$file/inside1280v2.jpg" border=0>

[This message has been edited by thekingofpain (edited 02-08-2001).]

[jaida]

thx kop knew i should have http://sysopt.earthweb.com/forum/smile.gif

just didn't have the time

btw thiemeMD nice water cooling setup



[This message has been edited by jaida (edited 02-09-2001).]

[voogru]

ThiemeMD! I like that setup! altho i have no use for a setup like that (I dont overclock my tbrid....yet) its a VERY nice setup.

good job http://sysopt.earthweb.com/forum/smile.gif

-voogru

[RayH]

The heart of the system:

<IMG SRC="http://www.webshots.com/photos/imgs3/28/11228-mid.jpg" border=0>

[JayMan]

1st off i'd like to apoligize the pics aren't the best quality, taken with my webcam since i got no digital cam hehe.

This one is really crappy, was taken at night and had bad lighting so is abit grainy lookin, i've drilled a few extra holes for the fans
<IMG SRC="http://www.geocities.com/jayman08/temp/fans.jpg" border=0>

The fans from the inside.
<IMG SRC="http://www.geocities.com/jayman08/temp/case_fans.jpg" border=0>

And this is the inside.
<IMG SRC="http://www.geocities.com/jayman08/temp/inside.jpg" border=0>

Here we can see part of my superorb, my prophet II PRO card, and my SB LIVE!
<IMG SRC="http://www.geocities.com/jayman08/temp/inside_down.jpg" border=0>

Heres the rest of the superorb and the other side of my prophet.
<IMG SRC="http://www.geocities.com/jayman08/temp/inside_up.jpg" border=0>

JayMan

[This message has been edited by JayMan (edited 02-11-2001).]

[JayMan]

Oh for anybody wondering, bottom fan on side of case is sucking into the case. Top fan on the side of tha case is blowing hot air out. Fan on the back of the case is sucking cool air in which basically feeds right onto/over the top of my superorb.

JayMan

[jl123]

Here ya go...this should help you guys out a bit. http://sysopt.earthweb.com/forum/wink.gif

http://sysopt.earthweb.com/forum/Forum1/HTML/009688.html

~Joel

[Mykex]

I recently re-did everything inside and did new pics,as always pics stink.
<IMG SRC="http://home.earthlink.net/~michaelwhit/_uimages/uplk1.jpg" border=0>
View of cables all rounded and wrapped.
<IMG SRC="http://home.earthlink.net/~michaelwhit/_uimages/drvcbl1.jpg" border=0>
Here as well.
<IMG SRC="http://home.earthlink.net/~michaelwhit/_uimages/frntfnz1.jpg" border=0>
This is my 80 intake with 120 delivering that air inside.
<IMG SRC="http://home.earthlink.net/~michaelwhit/_uimages/bksde1.jpg" border=0>
It's not at all child proof.
<IMG SRC="http://home.earthlink.net/~michaelwhit/_uimages/frnt1.jpg" border=0>
Pretty boring from the front real "sleeper" http://sysopt.earthweb.com/forum/wink.gif

[JayMan]

I think the next thing for me to do is round some cables and clean up the inside alittle, i think i will stick with heating and foilding rather than cutting hehe i don't trust myself that much.

JayMan

[Trey]

<IMG SRC="http://www.virtualhideout.net/images/link_eugene2.jpg" border=0>

[NDC]

Very unique PC case you got there, Trey! It certainly has good air ventilation at the top, I think you just need to tear some vents for the sides of the case! http://sysopt.earthweb.com/forum/wink.gif

[Biff]

Nice crisp photos there voogru. What camera u take them with?

Cool case Trey !

[voogru]

i take my pics with a EPSON PhotoPC 750z VERY nice camera but it only has a sieral connection and it downloads the pics very slow. other than that its pretty good.

[Biff]

Thanks voogru, maybe slow but they look sharp!
here is my setup, I also have the fan sucking air off the heat sink then duct it out the back.
<IMG SRC="http://members.home.net/biffland/biffbox.jpg" border=0>
Biff http://sysopt.earthweb.com/forum/smile.gif

[This message has been edited by Biff (edited 02-13-2001).]